Tapered Knob - High Visibility Yellow - presses on to any 1/2" diameter shaft

Tapered Knob - High Visibility Yellow - presses on to any 1/2" diameter shaft! Install knob over the end of a 1/2" outside diameter rod or tube. You can turn a 1/2" diameter bolt into a screw-in lever handle. Simply cut the head of the bolt off and drive the lever knob on by hammering it into position. It installs very tight - it won't ever twist or pull off. See some example uses in the photos below.

Features:

Made of tough ABS

The inside diameter of the knob is .462" so there is a tight interference fit when driving the knob onto a 1/2" shaft.

Knob will not fit 12mm bolts or shafts - it will be too loose

Pick up a few of these for any occasion where you need to make a lever knob for a project!

Length of knob: 1-13/16" Long.

Diameter of large end: .865"

Diameter of small end: .725"

Serrations on outside of knob surface prevent finger slippage

Weight: 12 grams

- Photo shows 3 knobs for display purposes only

We offer a special discount when you order 10 knobs - (Less than $1.00/each!)

Pick up a few of these for any occasion where you need to make a lever knob for a project!