3/4" Outside Diameter Internal Snap-in End Caps - TEXTURED Matte Black Surface

3/4" Outside Diameter Internal Snap-in End Caps - TEXTURED Matte Black Surface

These caps have rigid fins that will accommodate wall thicknesses of between (.035" to .075"). The inside diameter of your round tube needs to be within range from .600" to .680" for best results.

For best results: It is advised that all sharp burrs be removed from inside tube edges prior to installation.

If you find that your tube's inside diameter is slightly too small to install these caps, the outside ridges of the cap and be sanded down to accommodate the smaller tube ID.

Features:

Cap Outside Diameter: 3/4" Nominal - .740" actual measured

After installation, the face of cap extends .070" from tube end, crowned towards the center

Cap will install 7/16" deep into end of tubing

Made of high impact ABS plastic

Two rows of fins for extra strong holding force inside of tube

Easy to install - simply drive them into the open end of 3/4" O.D. Tubing of correct wall thickness

Matte black textured surface works well with just about any other color

Can be used to plug the end of tubing/pipe or to plug drilled holes for decorative purposes.

- Photo shows more than one for display purposes only