1" ID x 1.75" Long Rubber Ball-End Bumpers - Fits tight over any 1" O.D. Round Bar

1" ID x 1.75" Long Rubber Ball-End Bumpers - Fits tight over any 1" O.D. Round Bar to provide a thick and solid protective mass to the end of the bar with plenty of resilience. Used to terminate legs on furniture or rehab equipment. Or, use as protective (as well as decorative) bumper stops on cable attachments such as lat pull down bars and curl bars. Hollow tubes may be capped off to present a finished look. There are thousands of uses!

Features:

Made of indestructible black virgin rubber

Installs very tight over any 1" outside diameter round bar or tube

One end has a ball-shaped bulge that is 1.5" diameter

The minor outside diameter (shank) is approximately 1.166" diameter

The overall length of the bumper is approximately 1.75" nominal (1.775" actual measured)

The inside depth of the bore is approximately 1.030" deep, thus meaning the entire ball end is a solid rubber mass

- Photo shows more than one for display purposes only