The faux chrome-plated outer surface really brings the equipment to life! These are used just like our black plastic T-caps - just hammer them into the appropriate sized round tubing and you have a nice tight foam roller retaining system with a modernized contemporary look!
Protrudes only .375" from end of tube to provide a clean, low-profile finish to mounted foam rollers
Use in place of expensive shaft collars to retain foam rollers on shaft
Reduces the foot print by requiring less bar length vs. a shaft collar installation
Made of super strong ABS plastic with a chrome-plated appearance
T-Cap O.D. is 3" for greater surface holding area. Shaft collars allow foam rollers to "mushroom" over the collar due to smaller O.D. of the collar
Use a hammer to drive them into any inside diameter range of between .800" - .860" for a positive grip
1" OD pipe/tube with an .095" wall thickness is typically used for foam rollers which has a perfect I.D. for these T-Caps
T-Cap plugs extend a full 1-3/16" into the tube ID so they can't be knocked out easily
Ask about high quantity discounts!
- Photo shows more than one for display purposes only