2" x 4" Internal Snap-in End Cap - TEXTURED Matte Black Surface - Fits 11 - 14 Gauge

2" x 4" Internal Snap-in End Cap - TEXTURED Matte Black Surface - Fits 11 - 14 Gauge

This cap has flexible fins that will accommodate both 11 gauge or 14 gauge wall thicknesses (.120" to .075" wall thicknesses).

With some handy work, you may trim the fins so that this cap will fit 7 gauge (.188") wall tube. However the corners on the cap may not be a good match to the tube because a 7 gauge wall tube will have more rounding in the corners vs. an 11 gauge tube.

Once these caps are installed, they will not be removed easily

Features:

This is a multiple gauge cap - it fits both 11 gauge (.120" wall) & 14 gauge (.075" wall) versions of 2" x 4" rectangular tubing

After installation, the face of cap extends .120" from tube end

Cap will install 3/4" deep into end of tubing

Made of high impact ABS plastic

Four rows of fins for extra strong holding force inside of tube

Outside Dimensions of Cap: 2" x 4" Nominal (1.956" x 3.920" actual measured)

Easy to install - simply drive them into the open end of 2" x 4" rectangular tubing

Matte black textured surface works well with just about any other color

A very well-designed and sturdy end cap with lots of fins and brace supports molded in

Hard to find size!

- Photo shows more than one for display purposes only