Rubber Bumper - 1" Thick x 1.5" OD x 3/8" Bolt Hole

Rubber Bumper - 1" Thick x 1.5" OD x 3/8" Bolt Hole bumpers will allow the installation of a tough bumper just about anywhere. Can be mounted to protect the finish on weight racks, or to dampen metal-to-metal contact. Using a 3/8" bolt of an appropriate length, you can screw them into a tapped hole or through hole using a nut. The counterbore is large enough to allow clearance for both a 3/8" bolt head along with a 9/16" socket to tighten. After installation, the hex head is well below flush level and out of the way.

Features

Made of virgin neoprene rubber - won't crumble or crack

Great for stops or dampers to keep damage and noise down

Typical use is mounting on machines and racks where plate storage could damage finish

Outside Diameter: 1.5"

Height (thickness): 1"

3/8" Bolt Hole - actual ID is .335 but a 3/8" bolt fits tight

Bolt bore is countersunk so that mounting hardware is well below flush and out of the way

Counterbore for bolt head is .808" ID x .424" Deep

Simple installation using a single bolt

Bolt not included

- Photo shows more than one bumper for display purposes only

Ask about high quantity discounts!